I was using a Mac, and I actually found it in the App Store: Installing the Stock ASUS FirmwareĪfter the router is in the Recovery/Rescue mode, install the Firmware Restoration Utility and launch it. Settings will be back to factory defaults. Wait a few seconds, then release the WPS button. While keeping it pressed turn the router back on. Turn the router off, press the WPS button. Q: How do I wipe my settings? Reset button does not work.Ī: If the firmware fails to boot, then the reset button won’t work. Router will now be in Recovery Mode, reachable at 192.168.1.1.Ī: Press the reset button for more than 5 seconds, then release it. Wait a few seconds until the power led blinks, and then release the reset button. Press the reset button, and while keeping it pressed turn it back on. Q: How do I put the router into Recovery Mode?Ī: Turn the router off. If things get really bad you can use the following instructions which I found at the asuswrt-merlin FAQ page: This button resets or restores the system to its factory default settings. I noticed there are two procedures, from the Router’s Manual pdf: Resetting the Router to Factory Settings (Optional) Release the Reset button when the Power LED at the front panel flashes slowly, which indicates that the wireless router is in the rescue mode. Hold the Reset button at the rear panel and simultaneously replug the wireless router into the power source.Unplug the wireless router from the power source. ![]() To launch the rescue mode and use the Firmware Restoration utility:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |